FOLD N GO

68.5 lbs.
Sets up in about 10 minutes.

Fold N Go packed in its yellow travel case Fold N Go set up with fingertip controls, steering wheel and pedals

PLATFORMS / FOLD N GO

Unfold. Connect.
Train.

A portable forklift simulator that packs into one travel case. Physical steering, three pedals and fingertip controls, set up in about 10 minutes wherever your operators are.

Request a quote See the setup ↓
NEED A PERMANENT STATION? Classroom Standard Stays set up in your training room, always ready for the next operator. Same wheel, pedals and fingertip controls. See Classroom Standard
SETUP
About 10 minutes
CLOSED CASE
32 × 24 × 13 in.
WEIGHT
68.5 lbs
CONTROLS
Steering wheel, three pedals, fingertip controls
SOFTWARE
NEXUS · NEXUS+ · NEXUS LIVE

BUILT TO MOVE

From travel case to training station.

Everything packs into one case. Open it, unfold the controls, connect the laptop and headset, and start training.

  1. Fold N Go case open with the wheel, pedals and controls packed inside
    01

    Open the case

    Wheel, pedals, controls and cables are packed in place.

  2. Fold N Go with the fingertip control tower raised
    02

    Raise the controls

    Swing the fingertip control tower up and lock it.

  3. Fold N Go with the steering wheel raised and pedals set
    03

    Set the wheel and pedals

    Raise the wheel, connect the laptop and headset. Ready in about 10 minutes.

Loading the closed Fold N Go case into the back seat of a sedan
Fits in the back seat

ONE PERSON. ONE CAR.

No van required.

The closed case weighs 68.5 lbs and fits in the back seat of a sedan. Load it, drive to the next site, and set up in about 10 minutes.

  • 68.5 lbsClosed case
  • 32 × 24 × 13Inches, closed
  • ~10 minTo training

ON THE ROAD

Training goes where you go.

Two Fold N Go stations running NEXUS at a trade show: no shop floor, no forklift. Each case opens into a full operator station, then closes up and leaves with you.

Two trainees in VR headsets on Fold N Go stations at a trade show, with one trainee's headset view on a projector
Headset view on the big screen
A trainee driving a Fold N Go station in VR while a coach kneels beside him
Coaching on the spot
Fold N Go stations set up beside a projector screen at a trade show
Up and running at a trade show
Any roomBallrooms, classrooms, job-site trailers.
Side by sideRun more than one station in the same space.
Everyone watchesMirror a trainee's headset view on a projector so the group sees what they see.

WHAT'S INCLUDED

Everything you need to start training.

Each Fold N Go ships as a complete package. Final configuration is confirmed with your quote.

01

Fold N Go platform

  • Rugged travel case
  • Folding steering assembly
  • Logitech G29 steering wheel
  • Three pedals
  • Fingertip controls and direction selector
  • Hub and power connections
02

VR headset + laptop

  • HTC VIVE Focus Vision headset
  • Wired VR cable to the laptop
  • Dell Alienware 16-inch laptop
  • NVIDIA RTX 5060 graphics or better

Why this hardware? The headset is wired to the laptop, so it uses the laptop's full graphics power for the sharpest, smoothest VR. Hardware is bought new for every order, so you always get current models.

03

Training software

  • NEXUS: single driver, sit-down counterbalance skill drills
  • NEXUS+: adds stand-up counterbalance and stand-up reach, with a guided learning path
  • NEXUS LIVE: multiple drivers and an instructor in one shared VR warehouse
  • Preinstalled and ready to run, with an online portal for trainers, administrators and students

YOUR NEXT TRAINING ADVANTAGE

Take training to every site.

Request a quote Request a demo